Search
Search
Lorem Ipsum is simply dummy text of the printing and typesetting industry.
LVT
-
After installation, allow the adhesive to cure completely.
The planks may be walked on immediately after
installation, but should not be exposed to rolling loads
until 72 hours after installation. -
Do not mop the floor for at least 5 days after
installation. This will prevent excess moisture or
cleaning agents from interfering with the adhesive curing. -
Use RamBoard, FloorShell, Cover Too or similar breathable
flooring protection to protect the floor during any
construction that goes on after installation. Tape the
protection product to itself at the seams or to the
wall-baseboard at the perimeter, but never to the
flooring. -
Sweep or vacuum daily. Use only soft bristle attachments
for vacuums. -
Place walk-off mats at all outside entrances to reduce the
amount of dirt brought into the space. Do not use mats
with a latex or rubber backing since these backings can
cause permanent discoloration. - Clean up spills and excessive liquids immediately.
-
Damp mop as needed with water, or with a high-quality,
pH-neutral vinyl cleaner such as Bona Pro Series Luxury
Vinyl Floor Cleaner. Do not use solvent-based cleaners,
waxes, oils, bleaches, abrasive cleaners, or products
recommended for other types of flooring. Avoid any
cleaners that describe themselves as a polish,
‘rejuvenator,’ or ‘cleaner and polish in one.’ Polishes
can leave a residue that will dull the finish, collect
dirt, and can be extremely difficult to remove. -
Do not use scouring powder products, steel wool, or
abrasive cleaning implements on the floor. -
Use proper floor protection devices such as felt
protectors under furniture to prevent scratching. Under
desk chairs, protect the floor with a hard, solid mat.
Rubber, carpet or other soft chair mats may allow
indentations or other damage to the flooring. -
Avoid walking on your vinyl floors with cleats, sports
shoes and high heels. -
Do not roll, drag or slide heavy objects across the floor.
When moving heavy furniture, pick up the furniture
completely and place it on a protective surface such as
cardboard or plywood so that the furniture can be ‘walked’
along that surface. -
After installation, make sure that the flooring is never
be exposed to temperatures below 55˚F (13°C) or above 85˚F
(30°C). Direct sunlight on flooring can produce
surprisingly high temperatures. Window treatments may be
necessary to protect the flooring from high heat.
